extronics iWAP XN3, Installation And Operating Manual

Page: 17 / 28

XN3 Installation and Operating Manual
17
3.9 Data Connections
3.9.1 Copper Ethernet
Information Check that the line speed of the switch port to which the
XN3 is connected matches the XN3 port configuration,
otherwise communication may not be established.
If Copper Ethernet is specified, this will be terminated in a standard CAT5E RJ45
Socket on the front plate of the XN3, Position D in Figure 6. Typically, the interface
will be an IEEE 10/100/1000BaseT format, but this is dependent on the access
point installed.
Terminate the RJ45 plug as follows (EIA 568B standard):
3.9.2 Power-Over-Ethernet (POE)
If Power-Over-Ethernet (POE) is used, the format will depend on the access point
installed in the XN3. Ensure that the correct Power Sourcing Equipment (PSE) is
used. Connect the RJ45 cable per Section 3.9.1.
3.9.3 Optical Fibre
The XN3 optical fibre format may be any of the following, refer to product option
code #5 for details. Other optical formats are available on request.
MF 1000Bas
e-LX
LC Duplex
Multimode
-3 to -9.5dBm
(62/125µm)
-1 to - 9dBm
(50/125µm)
-19dBm -1dBm 1310nm 550m
SF 1000Bas
e-LX
LC Duplex Single -3 to -9.5dBm -20dBm -3dBm 1310nm 10km
Table 3: Fibre Formats
Pin Function
1 OE/WE
2 OE
3 GN/WE
4 BE
5 BE/WE
6 GN
7 BN/WE
8 BN
Figure 7: RJ45 CAT5E EIA 568B Plug Wiring