extronics iTAG 100, Operating Manual

Page: 5 / 22

Operating Manual
5
2 Safety Information and Notes
2.1 Storage of this Manual
Keep this user manual safe and in the vicinity of the controller. All persons who have to work
on or with the controller should be advised on where the manual is stored.
2.2 Essential health and safety requirements
This equipment is designed to satisfy clause 1.2.7 of the Essential Health and Safety
Requirement ANNEX II of directive 94/9/EC.
2.3 List of Notes
The notes supplied in this chapter provide information on the following.
•
Danger / Warning.
o
Possible hazard to life or health.
•
Caution
o
Possible damage to property.
•
Important
o
Possible damage to the tag.
•
Information
o
Notes on the optimum use of the device
Warning! This product can be delivered in a number of different variations, each
variant has restrictions on were it can be used. Please read the user
instructions fully and ensure that your iTAG100 is suitable for the
hazardous area which it is to be used in.
Warning! iTAG100-IIC and iTAG100-IIC-CB are both coated with a conductive
coating, users should check that this coating is not damaged before use.
Should the coating be damaged or scratched in an area which is greater
than 4cm² the iTAG100-IIC-xx should not be used in a hazardous area
which is greater than gas group IIC.
Warning! All iTAG100 devices should only be clean with a damp cloth.
Warning! All iTAG100 devices which are to be used in group II areas, should only
be fitted with the iTAG100-B1-II battery. This is a special battery which
has an encapsulated end, and should only be installed by a competent
person.