XTP T HWP 101 4K Wallplate Transmitter • Installation
8
Rear Panel Connectors
Figure 5.
XTP T HWP 101 4K Rear and Top Panel Connectors
A
XTP output connector
— Connect an XTP twisted pair receiver or matrix switcher
(see
Twisted Pair Cable Termination and Recommendations for XTP
on page 11) to the RJ-45 XTP output connector. The cable carries
the following signals:
•
Digital video
•
Digital audio
•
Remote power
•
System communication
Signal LED indicator
— Lights green when the transmitter outputs an XTP
signal to a compatible receiver or matrix switcher.
Link LED indicator
— Lights yellow when XTP devices are connected and
communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas cet connecteur à un réseau de télécommunications ou de
données informatiques.
•
XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
on
page 15).
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l’alimentation XTP à distance ne peut être routée en
extérieur (voir
à la page 15).
B
Power connector
— Connect the 12 V, 1.5 A power supply to the 2-pole captive
screw connector (see
on page 13). The Power LED lights to
indicate the device is receiving power.
NOTE:
The
XTP T HWP 101 4K can also be powered remotely (see
on page 15).
C
Configuration port
— Connect a host device to the female USB mini-B port to
configure the connected transmitter or update firmware.
XTP T HWP 101 4K
RESET
CONFIG
XTP OUT
POWER
12V
A MAX
0.3
A
B
C
Rear
Top
Signal
Link
Summary of Contents for XTP T HWP 101 4K
Page 6: ......
Page 8: ...XTP T HWP 101 4K Wallplate Transmitter Contents viii ...
