2
WAP 100AC Wireless Access Point • Setup Guide
Mounting to a Solid Ceiling or Wall
Wall or
Solid Ceiling
1
2
3
4
5
Turn the WAP 100AC about 90°
clockwise to lock it in position.
Figure 1.
Mounting the WAP 100AC to a Solid Ceiling or Wall
Extron provides a wall mounting hardware kit that includes:
•
Two wall plugs
•
Mounting bracket
•
Two P3.5 x 32 screws
•
Two P2.6 x 12 screws
To mount the unit, follow these instructions:
1.
Drill two holes 2.76 inches (70 mm) apart.
2.
Screw in the wall plugs
(
1
).
3.
Attach the mounting bracket (
2
) to the ceiling using the
P3.5 x 32 screws (
3
).
4.
Insert the
P2.6 x 12 screws (
4
) into the mounting holes
on the top of the WAP 100AC (
5
). Leave enough of the
screws exposed to insert the heads into the mounting
bracket.
If you need extra space between the WAP 100AC and
the mounting bracket, use the spacers and long screws
from the T-rail mounting kit (see
Mounting to a Dropped
Ceiling
on the following page).
5.
Connect the cables. The WAP 100AC can use a PoE
injector (recommended by Extron) or a 12 VDC desktop
power supply.
ATTENTION:
•
Do not connect either power supply before
reading the Attention notifications in the Power
Supply section of the
WAP 100AC User Guide
.
•
Ne branchez pas de sources d’alimentation
externes avant d’avoir lu les mises en garde
dans la section « sources d’alimentation » du
WAP 100AC User Guide
.
•
Disconnect power from either power supply
before making any connections.
•
Débranchez de sources d’alimentation externes
avant d’effectuer n’importe quelles connexions.
6.
Insert the heads of the P2.6 x 12 screws (see step 4) into
the holes in the mounting bracket.
7.
Turn the WAP 100AC about 90° clockwise to lock it into
place.
8.
Power on the PoE injector or 12 VDC power supply.
You are now ready to configure the WAP 100AC (see
Configuring the WAP 100AC
on page 5).
