VersaTools
®
MTP Series • Installation
VersaTools
®
MTP Series • Installation
Installation, cont’d
2-5
2-4
Furniture or projector mounting
(all except AAP and 45 models)
Use the optional mounting kit (furniture, part #70-212-01, or
projector, part #70-217-01) to mount the MTP as follows:
1
.
Remove the feet from the bottom of the MTP, if installed.
2
.
Attach the mounting brackets to the MTP with the
machine screws provided (figure 2-3).
Under Desk Mounting
Projector Mounting
Ceiling
Projector
Projector
M
ounting
Bracket
M
ounting
Bolt
Figure 2-3 — Desk and projector mounting the MTPs
3
.
For furniture mounting
—
a
.
Hold the MTP with the attached brackets against the
underside of the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
b
.
Drill 3/32" (2 mm) diameter pilot holes, 1/4"
(6.3 mm) deep in the mounting surface at the marked
screw locations.
c
.
Insert #8 wood screws into the four pilot holes.
Tighten each screw into the mounting surface until
just less than 1/4" of the screw head protrudes.
d
.
Align the mounting screws with the slots in the
brackets and place the MTP against the surface, with
the screws through the bracket slots.
e
.
Slide the MTP slightly forward or back, then tighten
all four screws to secure the MTP in place.
4
.
For projector mounting
, secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole.
Frame mounting (AAP models)
The AAP-mountable transmitters (MTP T SVA AAP and
MTP T AV AAP) can be mounted to any Extron AAP mounting
frame that accepts a double space (double height) AAP module.
See AAP accessories in the appendix for a partial list of AAP
devices.
The rear panel MTP connections will be inaccessible
after installation. Make all connections (see Transmitter/
receiver throughput connections, page 2-10) and test
the twisted pair system (apply a video source and observe
that transmitted video is displayed satisfactorily) before
installing the panel-mounted transmitter.
Install an MTP transmitter in an AAP frame as follows (figure 2-4):
MTP T AV AAP
AAP 102
AA
P 1
02
AU
DIO
VID
EO
L
R
MT
P T
AV
AA
P
Figure 2-4 — AAP mounting an MTP transmitter
1
.
If necessary, remove the AAP frame from the device in
which it is installed.
2
.
Cable the rear of the transmitter before fastening the AAP
module to the AAP frame.
3
.
Insert each of the AAP module’s screws through the holes
in the AAP frame. Secure the transmitter to the frame with
the provided captive washers and #4-40 nuts.
4
.
Install the AAP frame as appropriate to the type of frame.
Figure 2-4 shows the transmitter module being installed in
an AAP 102 wall mounting frame and the frame being
installed in a wall box.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
