3.
Set up the Touchpanels for Network Communication:
Connect the PC that you will use for setup, the control processor, and the touchpanel
to the same Ethernet subnetwork.
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read
the
•
Ne branchez pas les écrans tactiles ou les contrôleurs avant d’avoir lu les
Use the
(see page 9) or Toolbelt to set the DHCP status and, if
necessary, the IP address and related settings for the touchpanel.
NOTE:
Set up the touchpanel before mounting. Once the panel is mounted in a
wall, the
Menu
button cannot be accessed without removing the touchpanel.
4.
Mount and connect cables to the units:
Mount the units. There are several mounting options for Touchlink Pro touchpanels
(see
Connect cables to the touchpanels (see
TLP Pro 300M Rear Panel Features
Connect the power cords and power on all devices (see
5.
Configure the Touchpanels — the
GUI Designer Help File,
the
Global Configurator Help
File
, and the
Toolbelt Help File
, provide step-by-step instructions and detailed information.
The
Global Configurator Help File
includes an introduction to that software and sections
on how to start a project and configuration.
Global Scripter provides an Extron-exclusive Python library (ControlScript) and Global
Scripter modules to get you started. See the
GlobalScripter Help File
for more information.
TLP Pro 300M • Installation Overview
4
Summary of Contents for TouchLink TLP Pro 520M
Page 6: ......