z
TLP Pro 1020M
: BB 1000 or EWB 1000 kits
Follow the instructions provided with the kit.
Without a Wall Box
The touchpanels can also be mounted directly into drywall, without a kit.
ATTENTION:
•
Do not install the TLP Pro 720M or the TLP Pro 1020M in a fire resistant rated wall or
partition assembly.
•
Ne pas installer le TLP Pro 720M ou le TLP Pro 1020M dans un mur résistant au feu
ou une cloison.
The following steps show how to wall-mount theTLP PRO 720M. Furniture-mounting is similar.
1.
Determine the best location for the touchpanel and, using the template provided, mark the
wall and cut a hole:
z
TLP Pro 720M
— 7.5 inches (19.05 cm) wide x 5.81 inches (14.76 cm) high
z
TLP Pro 1020M
— 10.06 inches (25.55 cm) wide x 6.98 inches (17.73 cm) high
2.
Remove the bezel, using the Extron removal tool.
3.
Ensure that all the locking arms are flush with the unit and check that the touchpanel can fit
into the hole. If necessary, use a rasp or a coarse file to enlarge the hole.
4.
Run the network and video cables inside the wall to the hole, leaving enough slack in the
cables to connect them to the back of the touchpanel.
5.
Plug the cables into the
rear panel connectors
(see pages 8 - 13).
z
Connect the LAN port to the network with a straight-through cable, providing both a
network connection and power from a PoE power supply.
z
Optional:
Extron recommends using the PoE power supply provided. However, the
LAN port may be used as a network-only connection. Connect a 12 VDC, 1.0 A power
supply (not provided) to the 2-pole captive screw power input. See the
Attention
on
page 10 for very important information about power supplies.
6.
Push excess cables into the wall cavity.
Bezel snaps to unit
(2 tabs on each side).
Tighten screws to
rotate locking arms.
Locking arm (4)
Figure 20.
Secure the TLP Pro 720M to a Wall with Locking Arms
TLP Pro 720 Series and TLP Pro 1020 Series • Mounting
24