TouchLink Pro Control System Web Page
This provides general and network information about the unit in read‑only form (see figure 29,
below). Use the
(see page 16) or Toolbelt to configure the TLC network settings.
To access the TLC default web page, enter the IP address of the TLC into the web browser on
a device connected to the same subnet. A login page opens asking for your user name and
password. By default, the user name is
admin
and the password is the serial number of the TLC.
NOTE:
The factory configured passwords for all accounts on this device have been set
to the device serial number. If the device is reset, the password reverts to
extron
.
Passwords are case sensitive.
Figure 28 shows the TLC Pro 1026M web page. The web pages for the other control systems
are very similar.
Figure 28.
TLC Pro 1026M Web Page
All the information is read only.
To change any of the device network settings use the
Toolbelt (see the
Toolbelt Help File
).
To update firmware see see
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • Configuration Software
27
