Extron electronics TouchLink TLC Pro 526M Series, User Manual

Page: 32 / 49

System and GUI Project Panels
These panels are read only, providing information about the system, the Global Configurator
Project, and the GUI Designer Project.
Menu PIN
The PIN setup options allow you to enable, disable, or change the setup menu PIN. The PIN is a
4‑digit number. Each digit can have any value from 0‑9.
1. Enter a four‑digit PIN.
Enter New Menu PIN
4 5 6
7 8 9
0
2 1 3
Cancel
Back
Figure 23.
Numeric Keypad for Setting PIN
2. The title bar changes to
Confirm New Menu Pin
.
3. Enter the PIN a second time. When the PIN entered on the second occasion matches the
PIN entered on the first occasion, the PIN is set and the dialog closes.
Communication LED
The LED can be switched on or off by pressing the
Enable
or
Disable
button.
•
When this option is enabled, the Communication LED (see figure 2 , B , on page 6) is
active and shows the configuration and connection status of the touchpanel. It is unlit during
normal operation and lights steadily if the touchpanel has not been configured.
•
When this option is disabled, the Communication LED is not active.
Rear Status Lights
NOTES:
•
The TLC Pro 526M has no rear status lights.
•
The TLC Pro 726M has six lights (three on each side of the rear panel).
•
The TLC Pro 1026M has a single LED strip on each side.
These lights can be switched on or off by pressing the
Enable
or
Disable
button.
•
When this option is enabled, the rear status lights (see figure 3 ,
K
, on page 8) are
active.
The lights can be configured with Global Configurator to light green or red and to blink, light
steadily, or remain off. Different combinations (for example a red, steadily lit, LED can provide
feedback about the system.
•
When this option is disabled, the rear status lights are not active.
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • On-screen Menus 22