Extron electronics TouchLink TLC Pro 526M Series, User Manual

Page: 21 / 49

G
USB Port (see figure 3 on page 8) — Compatible with USB 2.0.
H
Speaker —
P
rovides audible feedback for the user.
•
TLC Pro 526M — a single speaker
•
TLC Pro 726M — a single speaker
•
TLC Pro 1026M — two speakers (support stereo or dual mono)
I
Mounting Plate Slot — The tongue at the bottom of the mounting plate fits into this slot,
for wall mounting (see Mounting on page 29) .
J
Mounting Screw — T
ightens against the tongue of the mounting plate to secure the TLC (see
Mounting ).
K Rear Status Light
•
The TLC Pro 526M — no lights.
•
The TLC Pro 726M — six LEDs (three on each side of the rear panel).
•
The TLC Pro 1026M has a single LED strip on each side.
The lights can provide system feedback:
•
Light red or green
•
Blink or remain steadily lit
The rear panel status lights of the TLC Pro 726M and the TLC Pro 1026M can be disabled,
using the
Setup Menu (see page 16).
The lights can be configured using Global Configurator, to provide feedback information
about the system using these variables.
Different combinations, for example a red LED lit steadily or a green LED that is blinking, can
provide indications about the system. For information about setting up these LEDs, see the
Global Configurator Help File .
L USB Adapter — Provides additional control ports (see “USB Adapter Features” below).
USB Adapter Features
Attaching the USB Adapter to the Touchpanel
1. Connect the adapter to the USB port (see figure 3 ,
G
, on page 8).
2.
Use the provided zip tie to secure the adapter to the back of the touchpanel.
S G IN 1 2 C Tx Rx Rx G Tx
IR/C IN COM1 RELAYS COM2
A A A
B B B C C C D D D E E E
Figure 5. USB Adapter Features
USB Port
Speaker
Mounting Plate Slot
Mounting Screw
Rear Status Light
USB Adapter
A
USB Connector — Insert into the USB Port
(see figure 3 ,
G
)
B
IR connector
C
Contact Closure connector
D
(2) Communications ports
E
(2) Relay ports
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • Panel Features 11