7
.
Connect the output device (PVS 204SA) cables to the rear
of the PVT wall plate. See "Rear Panel Features", later in
this manual, for connector wiring details.
8
.
Connect input devices (see "Front Panel Features",
later in this manual, for connector details), restore the
power supply, and test the wall plate. Make any cabling
adjustments before final installation, as the cables will be
inaccessible afterwards.
Final installation
After testing and making any adjustments, do the following:
1
.
Turn off the power supply to the PVS 204SA, and carefully
insert the wall box into the opening.
N
The transmitter's power is supplied by the PVS 204SA.
2
.
Secure the wall box with nails or screws, leaving the front
edge flush with the outer wall or furniture surface. See
figure 2-1.
N
If attaching the wall box to wood, use four #8 or #10
screws or 10-penny nails. A minimum of 0.5" (1.3 cm)
of screw thread must penetrate the wood.
If attaching the wall box to metal studs or furniture,
use four #8 or #10 self-tapping sheet metal screws or
machine bolts with matching nuts.
Signal
Output
Cable
Cable
Clamp
Wall Stud
Screws
or Nails
Wall Stud
Cable
Clamp
Screws
or Nails
Signal
Output
Cable
Figure 2-1 — Installing the wall box
3
.
Mount the transmitter into the box, and attach the supplied
Decora faceplate to the transmitter, as shown in figure 2-2.
4
.
Reconnect the cables and turn on the power supply to the
PVS 204SA. This powers up the wall plates.
Installation, cont’d
PVT Series (D and AAP models) • Installation
2-4
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
