2
68-2385-01 Rev. B
1
1
19
© 2013-2019 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
on the Extron website.
7.
Route the signal cables so that they exit the pipe via the cable access slot (see figure 3).
WARNING:
Do not thread any high voltage power cabling, such as power supply or projector power cords, through the
projector pipe. This violates the National Electrical Code.
AVERTISSEMENT :
Ne pas enfiler un câble d’alimentation haute tension, tel qu’un cordon électrique ou un câble de
projecteur, à travers le tube du projecteur. Cet acte est contraire au National Electrical Code (NEC) américain.
8.
Attach the cables to the switcher and pull any excess cable back into the ceiling. Feed the output cables to the projector via
the cable access slot to the base of the pipe.
9.
Continue installing the projector and other devices, following the directions of the relevant device manufacturer.
10.
Slide the covers onto the base plate, passing the AC power cord out through the power cord slot between the covers (see
figure 3).
11.
Slide the covers onto the base plate, passing the AC power cord out through the power cord slot between the covers).
Refer to the
PoleVault System Installation Guide,
, to complete the installation and setup.
LAN
1
LAN 3
LAN
2
LAN
4
L
R
DO N
OT
GRO
UND
OR S
HORT
SPEA
KER
OUTP
UTS 4/8
Ω
- - A MA
X
PO
WE
R
12V
HDMI
HDMI
1/2
SIG
LINK
SIG
LINK
3/4
5
6
INPU
TS
OUTPUT
AUD
IO OU
T
PVS
407D
AMPLIFIE
D AUD
IO O
UT
PAGI
NG
SEN
SOR
PVT IN
PVT I
N
L
R
AUX
OVER
PVT
REM
OTE
VOICELIFT
LAN
INPUT
7
+V
L
R
RS-23
2
Tx
Rx
IR
S
G
G
CLAS
S 2 W
IRING
LAN
PVS 407D
Switcher
Projector
Pole
Cable Access Slot
Cable Slot
Cover
Power Supply
Power Cord Slot
PVS 305SA IP
Switcher
Power Supply
Figure 3.
Attach the PMK to the pole, cable the PVS switcher, and then re-attach the
two covers (inset shows the PVS 305SA IP installation location).
2
figure3
