4
NBP 1200C • Setup Guide (Continued)
Step 3: Assemble AAP, Pass-through, and Power Modules
A variety of modules allow you to populate the Cable Cubby enclosure with a combination of AAPs, cable pass-through plates,
retractors, or power modules. The NBP 1200C accommodates your choice of any two modules, allowing you to customize the
device to meet your needs.
Assemble Connectivity Modules
The NBP 1200C ships with a single connectivity bracket that can be used with either the AAP frame plate or the cable grommet
plate. Follow the steps below to assemble the connectivity modules of your choice before mounting them into the NBP 1200C.
NOTE:
After assembling the modules, proceed to
Step 4: Install Modules and a Retractor Bracket
on the next page.
AAP module
The AAP module accommodates up to three
single-space AAPs. Assembly procedures are shown in
figure 2 at right,
Cable pass-through module
The cable pass-through module accommodates up to
eight AV cables. Assemble the cable grommet plate, and
plugs in the module as shown in figure 3 at right.
Secure up to three
single-space AAPs
in the AAP plate.
Secure the
AAP plate on
the connectivity
brackets using
four of the
provided
module screws.
#4-40 Nut with
Captive Washer
Insert cables through
the bottom of the
connectivity bracket.
Connect cables
to the AAPs.
1
3
2
Figure 2.
Assembling the AAP Module
Secure the grommet plate
on the connectivity
bracket using four of the
provided module screws.
2
Insert cables through the bottom
of the connectivity bracket
and into the holes
of the grommet plate.
You may need to bend
the plate gently to slide
the cable past the
slot opening.
Snap the included
hole plugs into any
unused holes.
1
3
Figure 3.
Assembling the Cable Pass-through Module
