Extron electronics IR 102, User Manual

Page: 14 / 16

Using the IR 102 with a Control System
IR 102 Rx
UNIVERSAL IR REMOTE RECEIVER
RS-232/
CONTACT OUT
RS-232
Tx Rx 1 2 3 4 5 +5
+12V
6
CONTROL OUT IR IN
CONTACT
MOD DEMOD
POWER
12V
.5A MAX
RS-232
IN
SW6 VGA Ars REMOTE 100-240V 0.2A INPUTS
1
2
3
4
5
50-60Hz
OUTPUT
OUTPUT
L R
SW6 VGA Ars
6
Universal Remote
INPUT/OUTPUT SELECTION
1234 5678 90
+10
ENTER
IR 102
REMOTE
IR 102 Rx Remote
Control Receiver
IR 102 Remote Control
IR Sensor
Up to 21' (6.4m) Cable
6' (1.8m) Cable
Power Supply
Control System/PC
SW6 VGA Ars Switcher
Figure 7. A Typical IR 102 Switcher Application
To use the IR 102 with a control system to control a switcher, use an RS-232 cable to
connect the IR 102 Rx remote receiver to the RS-232 connector on the switcher rear
panel.
The receiver uses the RS-232 interface of the switcher for input selection. It also has
an RS-232 input port to permit the switcher to be controlled by a computer or control
system, regardless of whether the switcher RS-232 port is occupied by the IR 102
remote receiver.
NOTE: The remote control can operate a switcher only if the switcher is configured
as master with no switchers slaved to it. See the switcher user guide to configure
the switcher.
IR 102 User Guide • Installation and Operation
6