IN1403 User’s Manual
14
Output menu
To access the output menu via the front panel control buttons, do the following:
1.
Press the desired Input Select button.
2.
Press
MENU
(press the
or
button to reach the output menu, if necessary).
3.
Press
ENTER
.
4.
Use the
and
buttons and the
ENTER
key to select the setting you wish to adjust.
5.
Press
ENTER
to save once you’ve optimized the setting for the current input.
Output Resolution:
This control lets you select the appropriate resolution for your display device.
The available resolutions are listed in the table under Output modes on page 18. Because the IN1403
only scales up, users must choose an output resolution that is greater than or equal to the input size.
For instance, you may not select 640 x 480 output with PAL input signals since PAL has more than 480
lines of video.
Of all the settings on the IN1403, perhaps the most critical adjustment is the output
resolution. Setting the scaler to match the capabilities of your data display device will have an
enormous impact on the image quality. To achieve the optimum image on your display
device, refer to the Choosing the Optimal Output Resolution and Refresh Rate section on page
15.
Refresh Rate:
Allows you to choose the optimal refresh rate for your display device.
Not all resolution and refresh rate combinations are available. Refer to the chart on page 18
for a complete listing.
Size
adjusts the output horizontal and vertical size. It shrinks the size to a percentage of the output
resolution selected. The output size is automatically reset anytime a new input aspect ratio is selected.
This setting is useful to manually reduce the height of the output signal when an anamorphic input
signal is connected. The IN1403 only scales up; therefore the output size controls will stop at a certain
point where the input and output resolution are equal.
Position
situates the output image on the monitor. The output position is automatically reset anytime
a new input aspect ratio is selected.
Sync Format:
Select an output signal format that is compatible with your display.
RGBHV--
:
RGB with negative horizontal and vertical sync (default)
RGBHV++
:
RGB with positive horizontal and vertical sync
RGBS A
:
RGB with composite sync (with serrations)
RGBS B
:
RGB with composite sync (without serrations)
RGsB A
:
RGB with sync on green (with serrations)
RGsB B
:
RGB with sync on green (without serrations)
Blue Screen:
Available anytime (even when the input settings are incorrectly adjusted or the input
signal is missing entirely), the blue screen may be used as a test signal to adjust the output settings
(resolution, refresh rate, size, position and sync format) and verify the image on the monitor. The
video and input settings have no effect on the blue screen. Once the output settings have been
properly adjusted and verified on the monitor, the blue screen may be turned off to adjust the video
and input settings.
Reset Output Settings:
Resets
all
output settings to factory default.
Advanced menu
To access the advanced menu via the front panel control buttons, press the desired Input Select button,
press
MENU,
press the
or
button (if necessary) to reach the advanced menu, then press
ENTER
.
Use the
and
buttons and the
ENTER
key to select the setting you wish to adjust. Once you’ve
optimized the setting for the current input, press
ENTER
to save.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203