Extron electronics DVC 501 SD, User Manual, Page: 37 / 38

$6#3$s2EFERENCE)NFORMATION 31
Through-desk Mounting
-OUNTTHECONVERTERTHROUGHADESKORTABLEUSINGTHEOPTIONAL-"$THROUGHDESK
mounting kit (see “ Optional Accessories ” for the part number).
1. If rubber feet are attached to the bottom of the unit, remove them.
2. Loosely attach the mounting brackets to the unit using the four machine screws and
washers supplied with the mounting kit.
Figure 28. Through-desk Mounting the DVC 501 SD
3.
(OLDTHE$6#AGAINSTTHEINSIDEOFTHESURFACETHROUGHWHICHITWILLBEMOUNTED/N
the inside of the mounting surface, mark the four screw holes and the material to be
removed (approximately 1.2 inches by 6.9 inches [3.0 cm by 17.5 cm]).
4. Cut out the table material. Test the fit by inserting the front of the transmitter through
the hole. If necessary, use a rasp or coarse file to enlarge the hole.
5.
Drill pilot holes, each 1/4 inch (6.4 mm) deep and 3/32 inch (2 mm) in diameter in the
desk or table where you marked the screw locations in step 2. The holes should be
DRILLEDFROMTHEUNDERSIDEORINSIDECONCEALEDSIDE OFTHEFURNITUREWHERETHE$6#WILL
be located.
6. 5SINGTHEFOURPROVIDEDWOODSCREWSSECURETHEBRACKETSTOTHEMOUNTINGSURFACE