DTP T EU 4K 331, DTP T EU 4K 231, DTP T MK 4K 331, and DTP T MK 4K 231 • Installation and Operation
12
Mounting the Transmitter
ATTENTION:
•
Ensure that the junction box is grounded properly.
•
Assurez vous que le boîtier d’encastrement est correctement mis à la terre.
Mount the transmitter to a junction box as follows:
1.
Disconnect power from all devices at the source.
2.
Orient the mounting bracket as appropriate for your transmitter (see figure 6):
•
MK mounting
— The word “Front” engraved on the bracket reads vertically.
•
EU mounting
— “Front” reads horizontally.
EU Mounting Bracket
EU Wall Box
Bezel Frame
DTP T EU
MK Mounting Bracket
EU Mounting
MK Mounting
MK Wall Box
Figure 6.
Mounting the Transmitter to a Junction Box
3.
Fasten the provided metal mounting bracket to the mounted junction box, in the proper
orientation, using the two included screws.
NOTES:
•
To keep the transmitter securely in place and prevent it from being easily pulled
from its mounting surface, ensure that the side of the bracket with the word
“Front” engraved on it faces
out
(away from the junction box).
•
If you want to be able to remove the transmitter easily from its mounting, attach
the mounting bracket with “Front” facing inward, toward the junction box.
4.
Run the TP cable and optional power cable through the junction box and the plastic
bezel frame.
5.
Set the TP function switch to the appropriate position (see item
A
on page 7).
6.
Connect the rear panel cables to the transmitter.
7.
Align the bezel frame to the metal mounting bracket on the mounting surface.
8.
Holding the bezel frame in place on the bracket, press the transmitter into the frame
until the unit snaps into place and all four tabs on the unit snap into their slots.