DTP T EU 4K 331, DTP T EU 4K 231, DTP T MK 4K 331, and DTP T MK 4K 231 • Installation and Operation
7
Installation Features
Top
Side
Rear
Front
HDBT
DTP
HDMI IN
0.7 A MAX
POWER
12V
C
E
B
D
D
A
B
Figure 3.
Installation Features
A
TP function switch
(see below)
B
TP port
(see page 8)
C
Power connector
(see page 8)
D
Electrostatic ground point
— Use the included grounding strap to ground the unit.
NOTE:
This ground eliminates electrostatic discharge only. This is not an electrical
safety ground.
E
HDMI input port
(see
Front Panel Connection
on page 15)
A
TP function switch
— If the receiving device is in the Extron DTP series, use a
DTP
HDTP
stylus or other tapered object to set this recessed switch to the DTP position. For
an HDBaseT-enabled receiver type, set this switch to the HDBT position. This
switch tailors the output signal as follows:
ATTENTION
:
•
Position this switch
BEFORE
connecting the appropriate device to the TP
connector. Failure to comply can damage the endpoint.
•
Positionnez le sélecteur
AVANT
de connecter l’appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager le
point de connexion.
HDBT position
— The TP output consists of HDMI with embedded audio.
DTP position
— The TP output consists of HDMI with embedded audio and remote
power.
NOTES:
•
When the switch is in the HDBT position
, the transmitter and receiver each
requires a local 12 VDC power supply.
•
When the switch is in the DTP position
, one 12 VDC power supply,
connected to either the transmitter or the receiver, can power both units.
