Summit WM3000 Series SW v5.1 – Clustering
32
© 2012 Extreme Networks, Inc. All rights reserved.
Building a Cluster from the CLI – L2 Topology
The procedure outlined for the CLI is recommended when deploying a new cluster. It is assumed that both WM3600-1 and
WM3600-2 are booted into a factory default configuration. No AP licenses have been installed.
A pictorial representation of a cluster is captured here. The profile default-WM3600 is applicable to both WM3600-1 and
WM3600-2. The configuration on WM3600-1 will be also configured on WM3600-2 and vice versa for WM3600-2.
Figure 1.
Profile WM3600 and default WM3600
WM3600-1 Configuration
Use the console port on the front of the controller to establish a connection with WM3600-1 and configure the following:
1. Initial setup
2. Hostname
3. Management IP address
4. Configure interface
5. Create VLAN (e.g. Vlan2) & assign IP address
