Summit WM3600 Wireless LAN Controller Installation Guide
21
Connecting USB Devices
The Summit WM3600 wireless LAN controller contains one USB port for connecting
USB flash storage devices to the controller. The controller can use the USB flash storage
device for file transfers and firmware updates. Follow the setup instructions below to
connect the devices to the controller and then access those devices through the Web UI
or Command Line Interface.
1
Connect the USB flash drive to the USB .
2
Wait a few seconds for the drive to be recognized by the controller.
3
Follow the instructions in the
Summit WM3000 Series Controller System Reference Guide
or
Summit WM3000 Series Controller CLI Reference Guide
for more information on
accessing USB storage devices from the controller for file transfers or firmware
updates.
NOTE
The controller supports USB flash devices formatted with FAT or VFAT (FAT32) filesystems only. If
your flash storage device is formatted with another filesystem you will need to format the device
before it can be used in the system.
Summary of Contents for Summit WM3600
