Extreme Networks ExtremeRouting SLX 9850-4, Hardware Installation Manual

Page: 61 / 158

Connecting a DC power cord
To connect a DC power cord to the power supply module, complete the following steps.
1. Attach the chassis ground lug to the chassis ground.
1. Chassis ground lug
2. Use a #2 Phillips screwdriver to unscrew the power lugs.
3. Obtain heat shrink tubing with the following specifications to install on the #2 AWG power supply input wire:
• Inside diameter: 1.27 cm (.5 in.)
• Minimum 2:1/50% shrink ratio
• Nominal recommended wall thickness: 30480 mm (.012 in.) minimum
• Dielectric strength: 800V/mil
• Tensile strength: Greater than or equal to 5000 psi
• Operating temperature: -40°C to +150°C (-40°F to 302°F) minimum
• RoHS-compliant
4. Cut off a 5.08 cm (2 in.) length for each #2 AWG power supply wire.
5. Slide the tubing over the #2 AWG power supply wire.
6. Crimp the #2 AWG power supply wire into the power lug.
7. Slide the tubing over the lug to the brown strip closest to the power lug holes.
Providing power to the device
ExtremeRouting SLX 9850-4 Hardware Installation Guide
9035474-02 Rev AA 61