Instructions d'installation professionnelle
Personnel d'installation
Ce produit est conçu pour une application spécifique et doit être installé par un personnel qualifié qui
possède des connaissances sur les RF et les règles associées. L'utilisateur général ne doit pas tenter
d'installer ou de modifier le paramètre.
Antenne externe
Utilisez uniquement les antennes approuvées par le demandeur. Les antennes non approuvées peuvent
produire une puissance de transmission RF parasite ou excessive indésirable, ce qui peut entraîner la
violation de la limite FCC / IC et est interdite.
Procédure d'installation
Reportez-vous aux instructions d'installation pour plus de détails.
Warning
Sélectionnez la position d'installation et assurez-vous que la puissance de sortie finale ne
dépasse pas la force définie dans les règles appropriées. La violation de la règle pourrait
entraîner de graves sanctions fédérales.
Safety Guidelines
The following safety guidelines are intended to protect your personal safety and prevent damage to the
equipment.
Attention
Only qualified personnel should perform installation procedures. Within the context of the
safety notes in this documentation, qualified persons are defined as persons who are
authorized to commission, ground and label devices, systems, and circuits in accordance with
established safety practices and standards. A qualified person understands the requirements
and risks involved with installing outdoor electrical equipment in accordance with national
codes.
Federal Communications Commission (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
Regulatory Information
ExtremeMobility AP460i/e Outdoor Access Points
38
