E
TREME
X
INE
- 43 -
EN
Stand 07/2014
8. Cleansing and maintenance
If the radiant heater is mounted outdoors it is important that it is cleaned regularly in order to
ensure a long durability and that it works efficiently.
The aluminium design of the radiant heater in connection with the anodized surface even pro-
tects the heater near the cost.
In order to achieve an optimal thermal output the heater`s surface must be cleaned regularly
by means of a moist cloth. It is particularly important that the radiator has been switched off at
least 60 minutes before cleaning it.
Otherwise there would be a higher risk of injuries and
burnings.
While cleaning the radiant heater always ensure that no votage/electricity is fed to the heater,
the control system or the accessory equipment and that the devices are unplugged and secured
against being switched on again.
Caution!
Do not use high-pressure cleansers or the like to clean the randiant heater. Besides, do never use
sharp objects and detergents. Make sure that no cleaning residues remain on the device.
9. Error Detection
Description of error
Reason
Correction
Radiant heater does not heat up
- wrong voltage
- no voltage
- the device is faulty
- check mains voltage
- maybe return device
Radiant heater smells burned.
- transportation locks are still on the
heating profile
- the device is faulty
- remove transportation lock
- maybe return device
Radiant heater is running, LED is
not skinning
- overtemperature protection is
activated - the device is faulty
- plug out and cool down device
- maybe return device
Radiant heater triggers residu-
al-current circuit-breaker or fuse
- device is wet
- the device is defective
- do not operate the device anymore
- maybe return device
Heating temperature is too low
- wrong or inappropriate assembly
instruction
- ambiance temperature too low
- Umwelteinflüsse, Temperatur,
Wind, Schnee
- check assembly instruction
