E
TREME
X
INE
- 39 -
EN
Stand 07/2014
5. Operation
After having mounted the device successfully, you can now put it in operation.
The radiant heater includes a LED which is built in the covering plate between teperature profile
and faceplate. As soon as the radiant heater is fed with electricity the LED begins lighting and
signalizes that the devise is in operating mode.
In connection with accessories, the LED may not light up, although the accessory is fed with
voltage/electricity. In that case, do refer to the respective manuals enclosed to the accessories.
Despite the fact that voltage is attached tot he radiant heater, the LED may not light as well, if
the overtemperature protection has been activated.
Do never forget to switch off the radiant heater!
6. Assembly Instructions and Minimum Distances
The following assembly instructions ensure that the radiant heater works effectively. All
minimum distances are mentioned and must urgently be kept to, regardless of the mounting
location.
1.
The radiant heater must be provided with an on/off switch (not included in scope of deli-
very, optionally available as accessory, see 4.6).
2.
The radiant heater can, depending on the assembly instruction and in case of optimal con-
ditions, reach a surface temperature of up to 380°C. Wind, humidity, ambient temperature and
the assembly instruction itself have a significant impact on the surface temperature.
3.
Make sure that the the mounted device is perfectly protected from influences of wind
and weather. Wind cools strongly down the device`s surface, whereby the sensed body heat is
influenced significantly.
4.
Do only mount the device in a roofed indoor or outdoor area.
5.
The radiant heater may never be mounted in a vertical position.