40.
Slide both stab/elevator assemblies onto the carbon fiber mounting tube and secure
with 2 3mm bolts. Insert the bolts through a washer and the mounting tabs and into
the corresponding blind nuts already installed in the fuselage. Use blue Loctite on
all bolts!!!
41.
Attach a 36" extension to the servo lead and install the servos with the output shafts
toward the rear of the fuselage using the manufacturer supplied mounting
hardware. Thread a ball link on each end of a titanium pushrod and secure to the
servo arm and elevator control horns with a 3mm bolt and nylon insert locknut. If
using the SWB 1.5 inch servo arm for elevator actuation use the inner hole on the
G10 control horns and trim the outer portion of the horn as shown in the picture. If
using a 1.75" servo arm use the outer hole on the G10 control horn. Be sure to use a
drop of blue Loctite on all bolts!!!
30
