15
(Aileron horn has been painted black in the following picture)
11. Locate the aileron servo mount and remove the covering from this area. Use a sealing iron to seal the
edges of the covering to the sides of the servo opening. Take a few minutes to apply some CA to the joints
of the servo mount and the ribs. This is very important as this area is under constant stress during flight.
12
.
Attach a 12 inch servo extension to the servo and secure with thread or heat shrink tubing. Use the
manufacturer supplied mounting hardware and install the servo with the output shaft toward the trailing
edge of the wing. Electronically center your servo. Aileron servo arm length should be 1.75” (2 inch arm
pictured using the hole at 1.75"). We use and recommend the SWB double lock aluminum arms. Thread
2 ball links onto each titanium turnbuckle pushrod. Secure the pushrod to the control horns and servo
arm as shown in the picture using the supplied 3mm bolts and nylon insert locknuts. As always, use blue
Loctite on ALL bolts!
