WARNINGS AND SAFETY DEVICES
8
Chapter 1
APPROVALS
The Extrafl ame boilers have been designed and realised in compliance with the following Directives:
UNI EN 303-5 Boilers for central heating. Boilers for solid fuel, with manual and automatic feeding,
with a nominal heat output up to 300 kW
Compliance with the Low Voltage Directive (73/23 EEC)
Compliance with the EMC Directive (Electromagnetic compatibility 89/336 EEC)
FOR SAFETY
The boiler must not be used by children or unassisted disabled persons.
Do not touch the boiler when you are barefoot or when parts of the body are wet or humid.
The safety and adjustment devices must not be modifi ed without the authorisation or indications of
the manufacturer.
Do not pull, disconnect, twist electric cables leaving the boiler, even if disconnected from the electric
power supply mains.
Do not close or reduce the dimensions of the airing vents in the place of installation.
The airing vents are indispensable for correct combustion.
Do not leave the packaging elements within reach of children or unassisted disabled persons.
The hearth door must always be closed during normal functioning of the product.
Avoid direct contact with parts of the appliance that tend to heat up during functioning.
Check for the presence of any obstructions before switching the appliance on following a prolonged
standstill period.
The boiler has been designed to function in any climatic condition (also critical). In particularly adverse
conditions (strong wind, freezing) safety systems may intervene that switch the boiler off .
If this occurs, contact the technical after-sales service and always disable the safety system.
If the fl ue should catch fi re, be equipped with suitable systems for suff ocating the fl ames or request
help from the fi re service.
If the boiler should block, indicated by a signal on the display and that is not relative to lack of routine
maintenance, contact the technical after-sales centre.
USE
These boilers must be used to heat water to a temperature that does not exceed boiling point in the
conditions of installation.
