Extraflame MIRKA, User Manual

Page: 19 / 40

1
2 3
4
5
6
1 4
3
2
5
6
19 ENGLISH
General menu
go back - exit
scroll parameters: next (3); previous (2)
Change settings data: increase (4); decrease (5)
Confirm - access menu
MODES SET
VENTILATION SET
*AIR DUCTING SET
**TEMPERATURE
*AIR ZONE CONTROL SET
EASY SETUP SET
CHRONO ENABLING
CHRONO MODE
PRG1
SETTINGS DATE-TIME PRG2
LANGUAGE PRG3
DISPLAY PRG4
STAND BY
DELTA-T
FIRST LOAD
***STOVE STATUS DEGREES
*PLus ONLY
**iF a temPerature PrOBe is CONNeCteD
***teCHNiCiaNs ONLY
RESET
EASY CONTROL
*** TECH MENU
General warnInGs
Advice to follow for the first start-ups of the product:
During the first hours of operation, there may be some smoke or
odours, but they are due to the normal “thermal break-in” process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š
Ventilate the room well
Š
if present, remove any majolica or natural stone parts from the
top part of the product
Š
activate the product at the maximum power and temperature
Š
avoid remaining in the room for a long time
Š
Do not touch the surfaces of the product
Notes:
the process is completed after a few heating/cooling cycles.
For combustion, do not use elements or substances other than those
indicated in the manual.
Before turning on the product, it is necessary to perform the
following checks:
Š if it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š the pellet hopper must be fully loaded
Š
the combustion chamber and the burn pot must be clean
Š make sure that the fire holder, the ash drawer and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š Check that the power cord is properly connected
Š
the switch (if present) must be set to position “1”.