ENGLISH
operation and loGiC
iGnition
Once the points listed previously have been checked, press key 1 for three seconds to ignite the stove. 15 minutes are available for the ignition
phase. after ignition and having reached the control temperature, the stove interrupts the ignition phase and passes to sTarTiNg.
preparation
During the start-up phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and pass on to wOrK.
work
During the work phase, the stove reaches the set power set; see following item.
set power
set the operating power from 1 to 5 (using keys 2 and 3).
Power 1 = minimum level - Power 5 = maximum level.
set h2o
set the boiler temperature from 65 to 80°C (using keys 4 and 5).
pump operation
The pump activates water circulation when the t° of the water inside the stove reaches approx. 60°C. as the pump always functions above 60°,
it is recommended to keep a heating area open at all times to allow for uniform operation, preventing blocks due to overheating. Normally
this area is defined as the “safety zone”.
Blow
During the working phase, the stove has an internal timer, which after a pre-set period of time cleans the burn pot.
This phase is shown on the display, it lowers the stove power level and increases the flue gas exhaust motor for a programmed period of time.
when the cleaning phase is finished, the stove will re-start automatically and continue the working phase, returning to the selected power
level.
modulation and h-off
as the water temperature approaches the set point, the boiler starts to modulate automatically bringing itself to the minimum power. if the
temperature increases beyond the set point, it will automatically switch off indicating
H-OFF
,
and will automatically go back on when the
temperature drops below the set point.
switCh-off
Press key 1 for three seconds.
Once this operation has been performed, the appliance automatically enters the switch-off phase, blocking the supply of pellets.
the flue gas exhaust motor and the hot air flow motor will remain on until the stove temperature has dropped below the default
parameters.
re-iGnition
The stove can only be re-ignited automatically or manually when the cooling cycle conditions and the preset timer have been satisfied.
do not use any inflammaBle liquids for iGnition!
do not allow the BaG of pellets to Come into ContaCt with the BoilinG hot stove durinG the
fillinG phase!
in the event of Continued failure to liGht, ContaCt an authorised teChniCian.
it is prohiBited to use the applianCe without the partition and/
or flame Guard (see fiGure on side). removal will Compromise the
safety of the produCt and result in the immediate nullifiCation
of the warranty period. in the Case of wear or deterioration,
request after-sales assistanCe for replaCement of the part
(replaCement that is not under Guarantee as the Component is
suBjeCt to wear).
Upper BUrN POTParTiTiON
20
Summary of Contents for 001282600
Page 1: ...MADE IN ITALY design production VIRNA IDRO 004276851 rev 002 UK THERMO PRODUCTS USER MANUAL...
Page 2: ...ENGLISH 2...
Page 38: ...ENGLISH 38...
Page 39: ...ENGLISH 39...