60
manual
3.5 Underwater light halogen
Follow the instructions in the enclosed
manual .
Place the underwater lamp preferably
70 cm (28 in) below the border edge
and provide an opening for the connec-
ting cable in the middle of a plank .
Before fitting the liner, drill a hole
(28 mm dia .) in the wooden structure .
After fitting the liner, and when the pool
is filled to just below this hole, push
the connector piece through and trace
the contours in order to cut the liner
correctly . Fit the lamp according to the
instructions provided, and guide the
cable outside via the connector piece .
Tighten the connector piece nut on
the outside . Connect the cable to the
electrical box .
If necessary, you must provide a cable
with the required diameter according to
the distance to the electrical box
(see the table in the manual provided) .
The underwater lamp must not be
switched on unless it is completely
submersed under water .
_____
3.6 Underwater light LED
Underwater light LED 35W / 12V -
16 colours, adjustable with the on/off
switch on the electrical box .
Follow the instructions in the enclosed
manual . Place the underwater lamp
preferably 70 cm (28 in) below the border
edge .
_____
3.7 Remote control for LED
Remote c receiver for under-
water light LED . Follow the instructions
in the enclosed manual .
_____
3.8 Felt
Felt is available in 6m width and 1 .3m
high . The 100% polyester material of
200gr/m2 is suitable for use both on the
inside to obtain a soft surface, as well as
on the outside of the pool as protection
for the wooden structure .
_____
3.9 Slide lock cover roller
The roller is used to easily remove or
install the summer tarpaulin .
_____
3.10 Internal stairs
Internal stairs for corner 90° for height
133cm and 146cm with adapted liner .
_____
3.11 Stainless steel finish for coping
_____
