8 SDL470-en-GB_v1.4 3/17
SD Card FORMATTING (Sd-F)
1.
From the
Sd-F
parameter screen use the arrow buttons to select YES to format the card
(select NO to abort). Note that all data on the card will be lost if formatting is attempted.
2.
If NO was selected, press ENTER to confirm and to move to the next parameter.
3.
If YES was selected, press ENTER and then press ENTER again when ‘ent’ is shown. The
meter steps to the next parameter automatically after the SD card is formatted.
4.
If desired, press and hold the SET button for 2 seconds to exit to the normal operation
mode (or wait 7 seconds for the meter to automatically exit).
Set the Temperature Units of Measure (C or F) ‘t-CF’
1.
From the
t-CF
parameter screen use the arrow buttons to select the desired unit of
measure.
2.
Press ENTER to confirm setting and to move to the next parameter.
3.
If desired, press and hold the SET button for 2 seconds to exit to the normal operation
mode (or wait 7 seconds for the meter to automatically exit).
Set the Thermocouple Type (K or J) ‘tYPE’
1.
From the
tYPE
parameter screen use the arrow buttons to select the desired sensor type.
2.
Press ENTER to confirm setting and to move to the next parameter.
3.
If desired, press and hold the SET button for 2 seconds to exit to the normal operation
mode (or wait 7 seconds for the meter to automatically exit).
System Reset
If the meter’s keys become inoperable or if the display freezes the Reset button can be used to
reset the instrument.
•
Use a paper clip or similar item to short press the reset button located on the lower right
side of the instrument under the snap-off compartment cover.
•
After pressing the Reset button, switch the instrument ON by pressing and holding the
POWER key for at least 2 seconds. If using the power adaptor unplug the adaptor and then
plug it back in again to power the meter.
