5
PRC30-en-EU_V1.3 7/14
OFFSET ADJUSTMENT
The offset adjustment can be used to correct any known linearity errors with the thermocouple.
1.
Select the measure mode and a thermocouple type (J/K/T/E/C/R/S/N).
2.
Press and Hold the SET button for 1 second to enter the offset adjust mode.
3.
Press the
▲
or
▼
button to change the offset value.
4.
Press and Hold the SET button for 1 second to zero the offset value.
5.
Momentarily press the SET button to save the change and exit the function.
►
◄
▼
and
▲
BUTTONS
The arrow buttons are used to adjust the output value in the SOURCE mode.
1.
Select the SOURCE mode
2.
Press the
►
or
◄
button select a digit for adjustment. The blinking underline curser
identifies the digit selected.
3.
Press the
▼
or
▲
button to adjust the value of the digit. Press and Hold the
▼
or
▲
button to
rapidly adjust the value.
SET BUTTON
The SET button is used to manually step through the 5 stored output values.
1.
Select the SOURCE mode
2.
Press the SET button and the value stored in memory location 01 will be sourced. “MEM.01”
appears in the display.
3.
Each press of the SET button will step through the 5 memory locations.
4.
The arrow buttons can be used to adjust the value in each memory location.
STEP/MEM BUTTON
The STEP/MEM button is used to automatically step through the 5 stored output values. The meter
can be set for a single cycle of the stored values or a continuous cycle.
1.
Select the SOURCE mode
2.
Press and Hold the STEP/MEM button. ”STEPSS” (single cycle) and “STEPSC” (continuous
cycle) will alternately appear in the display. Release the button when the desired mode is
displayed.
3.
In single cycle mode the meter will source the value displayed in MEM01 for 5 seconds. The
meter will then advance to MEM02 for 5 seconds. This will continue through MEM05 and
then step down through the memory locations. The cycle will end when MEM01 has been
reached.
4.
In the continuous mode the cycle will continue until manually stopped.
5.
Momentarily press the MEM button to stop the cycle. “END” will briefly appear in the display.
