475055-EN v2.5 3/14
5
Maintenance
Battery Replacement
The low battery indication appears as a "LO" on the display when battery voltage is less than 6.8V.
To replace the battery:
1.
Remove the two screws from the battery compartment cover.
2.
Lift off the battery cover.
3.
Replace with six (6) 1.5V ‘AA’ batteries.
4.
Replace compartment cover and screws.
Specifications
Range
220 lbs, 100kg, 980 Newtons
Accuracy (23
o
C)
±(0.5%rdg + 0.1lbs, 0.1kg or 0.4N)
Resolution
0.05lbs, 0.05kg, 0.2 Newtons
Overload Capacity
150kg
Circuit
Custom LSI microprocessor
Zero adjust
Button for Peak Hold and normal display zero
Display
5 digit LCD type; Digit height: 0.63” (16 mm)
Update Rate
Fast mode 0.2 seconds; Slow mode 0.6 seconds
Over range Indicators
LCD displays “
--------
“ for tension measurements and “
--------
“ for
compression measurements
Zero / Tare Control
Up to Maximum capacity
Full Scale Deflection
<1mm
Transducer type
S-type load cell with 2 hooks (thread size: M6 x 1mm ISO) and 6.5
ft (2m) cable
Peak Hold
Freezes Max reading on display
Data Output
RS-232 serial interface with 16-bit data stream output
Operating Temperature
32 °F to 122 °F (0°C to 50°C)
Operating RH
Max. 80% Relative Humidity (RH)
Power Supply
6 x 1.5V ‘AA’ batteries or 9VDC adapter (not included)
Power consumption
28mA (approx.)
Weight
Meter: 1 lb (450g)
Sensor: 0.84 lbs (380g)
Dimensions
Meter: 8.5 x 3.5 x 1.8” (215 x 90 x 45 mm)
Sensor with 2 hooks: 5.7 x 2.0 x 0.6” (145 x 51 x 15 mm)
Cable length: 6.5 ft. (2m)
Test Stand Mounting Holes Located on rear (thread size: M5 x 0.8mm ISO); mounting screws
included. Holes are 60mm apart
