11
EX
-
1188HMS
-
2
English
© Copyright 2018 by EXSYS Vertriebs GmbH. All Rights Reserved
6. Cleaning
4. Hardware Installation
Because there are large differences between PC’s, we can give you only a general in-
stallation guide. Please refer your computer’s reference manual whenever in doubt.
1.
Connect the USB cable to the USB B
-
Port at the Hub.
2.
Connect the included power supply to the 12V connector at the Hub.
3.
Now connect the other end from the USB cable (A
-
Plug) to the A
-
Port at your PC.
5. Driver Installation
All Operating Systems
After the hardware installation the OS will recognize the device automatically and install
the drivers.
CHECK INSTALLED DRIVER
Open the >
Device manager
<. Now you should see at „
USB
-
Controller
“
the following
new entry's:
If you see this or a similar information the device is installed correctly.
For cleaning please use only a dry fluff less cloth and remove the dirt with gently pres-
sure. In the area of the connectors please make sure that no fibres from the cloth re-
main in the connectors.
Attention! Never use a moist or wet cloth for cleaning!
