Page 24
9.5 Installing Welding Wire
-
-
-
-
-
-
-
-
-
-
-
Expressweld MasterMIG 500W
According to the procedure stated in
section on
Page 26, select the welding torch mode by using
Place the
located in the front of wire feeder unit
to O position.
Make sure that the torch equipment (spiral and nozzle) is suitable for the welding
wire being used and connect the welding torch to
located in the front panel of wire feeder unit.
After matching wire drive reels to each other which are suitable for the wire diameter
and wire type being used, connect the reels to wire feeder unit.
Open the cover of
located in the rear of
wire feeder unit.
Insert the welding wire reel to
as the end of
the wire will be on the lower part of reel.
If necessary, set the braking (tightening) torque of
When the reel stops, it shouldn t freely turn around the connection axis.
Cut the twisted end of the wire by taking out from open part of protector and file the
sharp corners.
Open the side cover of wire feeder unit.
Release the
by loosening.
Run the welding wire through the
of wire feeder unit.
Install the welding wire to
by running through wire drive reels.
After setting the press force by fixing again the
, start the machine with
located in the front panel
of power unit.
Press the
located in the front panel
of wire feeder unit. During this action, always make sure that the contact nozzle of
welding torch is not in place. You can set the wire feed speed with
ocated within the wire feeder unit.
Release
after the welding wire is
seen and install the contact nozzle and gas nozzle to the welding torch and tighten
properly.
“
”
“
”
“
”
“
“
”
”
“
”
“
“
”
“
”
“
”
“
”
”
“
”
Wire Feeder Unit Functions
2/4 Trigger Selection Switch
Wire Feed Speed Setting Button
Torch Connection Socket"
Placing Welding Wire into Protective Cartridge
Welding Wire Reel Protection Cabinet
"Welding Wire Reel Connecting Shaft
Welding Wire Reel Connecting
Shaft
Installing Welding Wire to Wire Drive Unit
Wire Feed Reel Press Forced Setting Spindle"
Wire Inlet Guide
Wire Outlet Guide
Wire Feed Reel Press Forced
Setting Spindle
On/Off Switch
"Wire Feed Control Without Welding Button
Wire Feed
Speed Without Welding Setting Button l
“Wire Feed Without Welding Control Button”
.
“ ”
.
'
