6V
12V
WARNING! IF THE NEXT STEPS ARE NOT PERFORMED CORRECTLY YOU MAY
DAMAGE YOUR BIKE, LIGHT; OR BOTH.
The lights will draw as much power as they require to run the LEDs at their brightest. This means
that if the light can draw more power than is available from the bike it may damage the bike motor.
Ensure to match the current setting of the light to the power output of the bike.
The light will automatically detect the voltage of the motor you’re plugging it in to. To select the
correct power setting,
hold the button down for 20 seconds
(the light will emit a rapid set of
flashes) then follow the tables below:
When the light is off a single button press will indicate the active current limit by the button colour.
CURRENT
BUTTON INPUT
BUTTON FEEDBACK
1.5A
HOLD BUTTON FOR 20 SEC,
RELEASE BUTTON
GREEN
2A
HOLD BUTTON FOR 20 SEC,
RELEASE, PRESS BUTTON
ONCE
AMBER
2.5A
HOLD BUTTON FOR 20 SEC,
RELEASE, PRESS BUTTON
TWICE
RED
CURRENT
BUTTON INPUT
BUTTON FEEDBACK
1A
HOLD BUTTON FOR 20 SEC,
RELEASE BUTTON
GREEN FLASH
1.5A
HOLD BUTTON FOR 20 SEC,
RELEASE, PRESS BUTTON
ONCE
AMBER FLASH
2A
HOLD BUTTON FOR 20 SEC,
RELEASE, PRESS BUTTON
TWICE
RED FLASH
For more information please visit:
For more information please visit:
exposurelights.com
exposurelights.com
EXPUG22
EXPUG22
#ownthenight
