account should the old cartridge be used
again as the sterilising agent will have
saturated the filter bed.
After fitting the new filter flush the system for
around 30 seconds to remove any loose
particles of carbon. It is recommended that a
new filter is fitted at the sort of each season
after sterilising the system and again after
approximately 30 days usage as the filter
becomes less effective after this period.
On no account should the old cartridge be
used again as the sterilising agent will have
saturated the carbon bed.
TAPS
WHALE ‘ELITE’ MICRO SWITCH TAPS
(FITTED IN CALYPSO ONLY)
The micro switch taps are used when the water
supply is not pressurised. When the tap is
turned on the micro switch (which is fitted
inside the tap) activates the pump to supply
water.
OPERATION
Swivel the tap spout (a) to the desired position
over the sink, lift the control lever (b) to activate
the pump and allow water to flow
simultaneously. To adjust the temperature
swivel the lever (c) to the left or right as shown
below.
CLEANING
It is recommended that a non-abrasive damp
cloth is used for cleaning the Elite Tap/Shower.
Microswitch Replacement:
A microswitch
replacement kit is available (ref. MT8000).
NOTE:
Before commencing microswitch
replacement ensure instructions are read
through thoroughly. The entire process can be
completed without the need to remove the tap
from the worktop.
BEFORE YOU START
1. Ensure pump is isolated.
2. Position lever in central, i.e. mixer, off
location.
MICROSWITCH REPLACEMENT
1. Carefully remove lever cap. A recess at the
back of the lever cap is provided to assist
with this.
2. Remove screw with No. 2 Pozi screwdriver.
Note the position of the lever at this stage.
3. Lift off the lever.
4. Note the position of actuator before
removal. Flange should be facing forward.
5. Remove
actuator.
6. To remove shroud, squeeze clips with one
hand and slide shroud off with other hand.
7. Remove microswitch, using finger and
thumb, pull up and outwards.
8. Slide wire terminals off microswitch.
9. Attach replacement microswitch and
relocate. Note: Ensure microswitch snaps
fully home.
10. Before relocating shroud ensure wires are
neatly located in the front groove as
shown.
11. Replace shroud. Note: Ensure shroud
locating rib is aligned with the rear groove
of tap and snap fully home, ensuring clips
are retaining the shroud.
12. Replace actuator in position noted in 4
above.
26
MOTORHOME EQUIPMENT
Summary of Contents for 2003 Autostratus FB
