10
Operating Instructions (continued)
Cleaning and Care
Before Each Use:
1 . Keep the grill area clean and free from any combustible materials, gasoline, and other flammable vapors and liquids .
2 . Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air .
3 . Keep the ventilation opening(s) of the LP gas tank area free and clear from debris .
4 . Visually check the burner flames to make sure your grill is working properly (Figure 8) .
5 . See sections below for proper cleaning instructions .
6 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the burner/venturi tube . A clogged burner tube can lead
to a fire .
Cleaning Surfaces
1 . Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water .
2 . For stubborn surfaces, use a citrus-based degreaser and a nylon scrubbing brush .
3 . Rinse clean with water .
4 . Allow to air dry .
Cleaning Main Burners
1 . Turn LP gas tank valve to “CLOSED .”
2 . Turn all control knobs clockwise to the “ OFF” position .
Note: A “poof” sound is normal as the last of the gas is burned .
3 . Disconnect LP gas tank per “Disconnecting LP Gas Tank” section .
4 . Remove cooking grids and heat plates .
5 . Remove burners by removing the fasteners, which secure the burners to the grill bottom .
Figure 8
Burner Flame Conditions
Use this chart to see if your burners need to be
cleaned .
1-2 in. /
25.4 - 50.8 mm
Normal:
Soft blue flames with yellow
tips between 1 in . - 2 in . height .
Needs cleaning:
Noisy with hard
blue flames .
Has to be replaced:
Wavy with
yellow flames .
.
1. All cleaning and maintenance should be
done when grill is cool and with the fuel
supply disconnected.
2. Do NOT clean any grill part in a self-
cleaning oven. The extreme heat will
damage the finish.
3. Do NOT enlarge valve orifices or burner
ports when cleaning the valves or burners.
.
1. This grill should be thoroughly cleaned and
inspected on a regular basis.
2. Abrasive cleaners will damage this product.
3. Never use oven cleaner to clean any part of
grill.
CAUTION
NOTICE
Operating Side Burner
NOTE:
Side burner can be used while main burners are operating .
Never use side burner as a grill .
W
CAUTION: Maximum weight for side burner and side shelf is 22 lbs.
W
CAUTION: Using pots larger than 6 quarts in capacity could exceed weight limit of the side burner shelf, resulting in failure of grill cart components.
W
CAUTION: Do NOT lean on the side burner shelf.
W
CAUTION: Attempting to light the burner with the lid closed may cause an explosion.
Lighting
1 . Open lid .
2 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the burner/venturi tube A clogged burner tube can lead to a fire .
3 . Control knob must be in the “ OFF” position (Figure 3) .
4 . Connect LP gas tank per “Installing LP Gas Tank” section .
5 . Turn LP gas tank valve to “OPEN .”
6 . Push and turn control knob to (HIGH) . The burner should light . If not, repeat up to three times .
7 . If ignition does not occur in 5 seconds, turn burner control knob “ OFF,” wait 5 minutes and repeat lighting procedure .
8 . If igniter does not light burner, use a lit match secured with the lighting rod (included with grill) to light burners . Position the lit match near side of the burner (Figure 7) .
Important:
Always use the lighting rod (included) when lighting burner with a match .
9 . After lighting, observe the burner flame . Make sure all burner ports are lit and flame height matches illustration (Figure 6) .
W
CAUTION: If burner flame goes out during operation, immediately turn the control knob to the “ OFF” position and LP gas tank valve “CLOSED” and
open lid to let the gas clear for 5 minutes before re-lighting.
Turning Off
1 . Turn LP gas tank valve to “CLOSED .”
2 . Turn control knob clockwise to the “ OFF” position .
Note: A “poof” sound is normal as the last of the LP gas is burned .
3 . Disconnect LP gas tank per “Disconnecting LP Gas Tank” section .
Cooking
1 . Open lid and ignite the side burner per “Lighting” instructions .
2 . Adjust control knob to desired flame height .
3 . Place pan on center of grid .
4 . Cook and adjust temperature as needed .
5 . Turn grill off per “Turning Off” instructions .
Figure 7
Lighting
Rod
Match
