86
SunSDR2 DX User Manual
© 2020 Expert Electronics
ExpertSDR2 SOFTWARE DESCRIPTION
I F – tuning the frequency by moving the filter over the panorama.
RF G ain – RF Gain control.
CW Speed – CW Speed control.
RI T Of f set – adjusting the RIT Offset.
XI T Of f set – adjusting the XIT Offset.
In the right part of the menu you can see the main panel settings:
Enable - enable E-Coder panel control.
Use I F - frequency tuning by moving the filter over the panorama.
Use I F as RI T - tuning by IF when the RIT offset is on.
Use I F as XI T - tuning by IF when the XIT offset is on.
VFO B - enable sub-receiver.
Key Led - enable backlit keypad.
Encoder Led - enable backlit encoder.
Select RX1 or RX2 receiver.
No t ransf er PTT -
PTT t o TCI – enable reroute of the PTT signal from the panel to TCI, has higher priority than
PTT t o COM port .
PTT t o COM port - rerouting of the PTT signal from the panel to the COM-port. Set the PTT t o
COM port checkbox to enable rerouting the PTT signal.
Port name - COM-port number.
DTR/RTS - select the COM-port line, which is used for transferring the PTT commands. Set
one of the DTR/RTS line checkboxes to set it as the control line.
Volume - set the volume change step, per knob's clack.
Mic G ain - set the Mic gain change step, per knob's clack.
SQL - set the squelch threshold change step, per knob's clack.
Filt er High - set the filter's high limit change step, per knob's clack.
Filt er Low - set the filter's low limit change step, per knob's clack.
Filt er Widt h - set the filter's width change step, per knob's clack.
Filt er Shif t - set the filter's shift change step, per knob's clack.
Drive - set the output level power change step, per knob's clack.
RF G ain - set the RF gain step, per knob's clack.
Summary of Contents for SunSDR2 DX
Page 2: ......
