7
The straight shaft trimmer attachment is fully assembled at the
factory and requires no further assembly.
JOINING THE POWER HEAD TO THE
STRAIGHT SHAFT TRIMMER ATTACHMENT
See Figure 2.
WARNING
Never attach or adjust any attachment while power head is
running. Failure to stop the engine may cause serious
personal injury.
The straight shaft trimmer attachment connects to the power
head by means of a coupler device.
1. Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment shaft.
2. Push in the button located on the straight shaft trimmer
attachment shaft. Align the button with the guide recess
on the power head coupler and slide the two shafts
together. Rotate the straight shaft trimmer attachment
shaft until the button locks into the positioning hole.
NOTE:
If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked into
place.
3. Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious injury or product damage.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
1. Loosen the knob.
2. Push in the button and twist the shafts to remove and
separate ends.
STRAIGHT SHAFT
TRIMMER ATTACHMENT
POWER HEAD SHAFT
GUIDE RECESS
COUPLER
KNOB
POSITIONING
HOLE
Fig. 2
ASSEMBLY
