Figure 13
1.
Torque sheave nut to
140-145 ft-lb (190–197
N-m).
2.
Install with cone towards
nut.
Check blade bolt torque after completing this
installation.
For units with a 5/8-18 x 2 3/4 inch blade bolt,
torque to 115-120 ft-lb (156-163 N-m).
8. Re-install the deck drive belt in the lower groove of
the double sheave. Install the plug (item 40) into the
bore of the double sheave.
Units Serial Number 599,999 and Lower
With Splined Blade Driver:
1. Stop the engine, remove the key, and wait for all
moving parts to stop.
2. Lower the deck fully. Remove the right hand belt
cover. Remove the belt cover mounting stud that
protrudes from the deck.
3. Remove the right side belt shield and the 5/16 x 3
1/4 inch bolt that secures the shield to the deck.
4. Remove the blade from the right spindle.
5. Insert special tool 109-2979 into splined end of
spindle shaft.
6. Remove the right sheave nut, spring disc washer, and
drive sheave from the spindle shaft– keep hardware
for re-use.
Use special tool 109-2979 to hold spindle from
rotating. Do Not use the blade bolt to prevent
rotation.
7. Apply a light coat of Mobil HTS grease (or food
grade antiseize) to the top portion of the spindle
shaft where the sheave mounts.
8. Install the double sheave (item 12) onto the right
spindle shaft. Install the spring disc washer and
nut. Make sure that the spring disc washer cone is
installed towards nut (see Figure 14). Torque the
sheave nut to 140-145 ft-lb (190-197 N-m).
Use special tool 109-2979 to hold spindle from
rotating. Do Not use the blade bolt to prevent
rotation.
Figure 14
1.
Sheave nut-torque to 140-145 ft-lb (190-197 N-m)
2.
Spring disc washer (cone towards nut)
3.
Double sheave (item 12)
4.
Special tool 109-2979
9.
Reinstall the blade and torque bolt to:
For units with a 1/2-20 x 2 inch blade bolt,
torque to 50-60 ft-lb (75-81 N-m).
10. Reinstall the deck drive belt in the lower groove of
the double sheave. Install plug (item 40) into bore of
double sheave.
Units Serial Number 600,000 and
Higher:
1. Stop the engine, remove the key, and wait for all
moving parts to stop.
2. Lower the deck fully. Remove the right hand belt
cover. Remove the belt cover mounting stud that
protrudes from the deck. Save the knob for later use.
3. Remove the blade from the right spindle.
4. Insert the special tool 109-2979 into splined end of
the spindle shaft.
5. Remove the right sheave nyloc nut, washer, and
splined washer from the spindle shaft. Do Not
remove the blade drive sheave. Retain the nut for
later use.
11
