7
3.2 INSTALL THE HOPPER ASSEMBLY
Lazer Z XP, Lazer Z XS and Lazer Z SN 510,000 & Higher units only (Lazer Z SN
352,000 – 509,999 units skip to section 3.2.9)
NOTE:
Units with a 2 post folding ROPS installed, the ROPS must be temporarily
removed for installation of the Ultra Vac QDS.
For Lazer Z units SN 510,000 and Higher:
3.2.1 When installing the Ultra Vac QDS onto a liquid cooled Lazer Z, the rear bumper
plate must be removed. Remove rear bumper plate. Reattach the lower side
bumper bars to the vertical “HOT” engine guard shield using two of the original
screws, washers and whizlock nuts removed from the bumper plate.
3.2.2 Remove the lower two screws holding the rear engine guard (“HOT” engine guard
on liquid cooled units) to the rear frame of the Lazer Z unit.
3.2.3 Install the mount weldment (Item 9) loosely to the rear of the machine using the
two screws and nuts removed in section 3.2.2.
For Lazer Z XP and Lazer Z XS units:
3.2.4
Install rear mount weldment (Item 9) loosely to the rear bumper using the two
holes provided. Use the 3/8-16 x 1.00 screws (Item 23), 3/8 spring disk washers
(Item 25) and 3/8-16 whizlock nuts (Item 24).
For Lazer Z XP, Lazer Z XS and Lazer Z SN 510,000 and Higher units:
3.2.5
Attach the handle assembly (Item 7) onto frame bracket (Item 16) using 3/8-16 x
1.00 screws (Item 23), 3/8 spring disk washers (Item 25) and 3/8-16 whizlock
nuts (Item 24). Make sure that the raised portion of the spring disk washer faces
the head of the screw.
3.2.6
Install the frame brackets (Item 16) and spacers (Item 17) loosely to the mount
weldment (Item 9). Use (2) 3/8-16 x 1 screws (Item 23), (2) 3/8 spring disk
washers (Item 25) and (2) 3/8-16 whizlock nuts (Item 24). Make sure that the
raised portion of the spring disk washer faces the head of the screw.
3.2.7
For units without a ROPS installed:
Install the frame brackets (Item 16) to the
mounting pads on the Lazer frame. Use (4) 3/8-16 x 1 screws (Item 23), (4) 3/8
spring disk washers (Item 25) and (4) 3/8-16 whizlock nuts (Item 24).
3.2.8
For units with a ROPS installed:
Install the frame brackets (Item 16), and ROPS
lower roll bar tubes
LOOSELY
to the mounting pads on the Lazer frame. Use
the ROPS mounting hardware, 3/8-16 x 1 1/2 screws, 3/8 spring disk washers
and 3/8-16 whizlock nuts. Make sure that the raised portion of the spring disk
washer faces the head of the screw. See Figure 4.
FIGURE 4
LOWER ROLL BAR INSTALLATION
