15
FIGURE 10
Lazer Z units SN 440,000 and higher:
3.5.8 Locate the position of the mounting holes by aligning the template (P/N 103-5865)
on the front face of the floor pan as shown in Figure 11. Clamp the template in
place. Using a center punch, mark the positions of the holes on the floor pan. Flip
the template over and repeat on the other end of the floor pan face.
FIGURE 11
3.5.9 Drill 3/8” holes at the points marked.
3.5.10 Follow steps 3.5.6 through 3.5.7 for weight installation (See Figure10).
3.6 INSTALL THE CASTER WEIGHTS
Note: The caster weights are heavy. Use care when lifting them. Make sure that
you can hold them securely before lifting them. Use caution when positioning
your hands so that you do not set them down on your hands or fingers.
3.6.1 Assemble the weight brackets (Item 33) to the caster weights (Item 11) using the
3/8-16 square head bolts (Item 34) and 3/8 whizlock nuts (Item 25).
Unit
1.5” Bracket
2.0” Bracket
Lazer Z 60” Units
1
1
Lazer Z 72” Units
2
Lazer Z XP 60” Units
2
1
Lazer Z XP 72” Units
2
Lazer Z XS 60” Units
2
2
Lazer Z XP 72” Units
2
1
Second 2.0” bracket is included in Ultra Vac XS completion kit 103-7876.
2
Second 2.0” bracket is included in Ultra Vac XP completion kit 103-7420
.
3.6.2 Install the caster weight assemblies over the
caster arms. On 60 inch Lazer Z machines one
weight has a wide mounting bracket and one has
a narrow bracket. They will only fit the machine
one way. Weights for the 60 Lazer XP, 60” Lazer
XS, and all 72’s are interchangeable left and right.
3.6.3 Install a clevis pin (Item 19) and hairpin (Item
20) on each caster weight to retain them.
3.6.4 Tighten knob on weight assembly until the
weight is clamped securely to the caster arm.
FIGURE 12
Align template along
these 3 edges.
