TURF TRACER
®
S-SERIES
Setup Instructions
For Serial Nos. 313,000,000 & Higher
Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
Description
Qty.
Use
107-4543
Clamp, Tank
2
322-10
Screw, HH 5/16-18 x 2
2
3256-3
Washer, 5/16 Std
2
104-8300
Nut, Nyloc 5/16-18 Flg
2
Installing the fuel tank.
323-6
Screw, HH 3/8-16 x 1 inch
4
3290-357
Nut, Whizlock 3/8-16 inch
4
98–5975
Washer, Spring Disc
4
Installing the handle assembly.
1-806003
Hairpin, Cotter
1
3272-5
Pin, Cotter 3/32 x 1/2 inch
1
1-808280
Pin, Clevis
1
Installing the speed control rod.
322-9
Screw, HH 5/16-18 x 1 3/4 inch
2
3296-29
Nut, Nyloc 5/16-18 inch
2
3220-16
Nut, Jam 3/8-24 inch LH
2
Installing the wheel drive linkages.
1-303335
Tie, Cable
2
1-303287
Tie, Cable
4
Connecting wire harness.
103-2106
Key, Exmark Logo
1
1-603511
Key, Standard
1
Fill out the online warranty registration
form and place keys into literature
pack.
Literature Pack
Manual, Operator's
Manual, Engine Operator's
Uncrating the Unit
1. Leaving the unit on the pallet, place the upper handle
assembly and the fuel tank at the rear of the machine.
2. Remove the bolt bag from under the mower deck
belt shield.
3. Refer to the parts manual to help you identify and
locate the parts and their proper position.
Installing the Fuel Tank
1. Install the fuel tank on top of the fuel tank support.
Secure each side of the tank with a clamp, 5/16-18 x
2 inch screw, washer, and 5/16 inch nyloc nut.
2. Attach the fuel supply hose to the bottom tank fitting
and secure with the clamp provided.
3. Attach the purge hose from the tee on the engine
(canister on CA units) to the top fitting of the fuel
tank as shown in Figure 1. Press the hose into the
slot on the tank to retain it.
© 2012—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Part No. 4501-436 Rev. A
Printed in the USA
All Rights Reserved
