3.
Locate the left and right weight-mounting
brackets in loose parts.
4.
Install the left bracket to the under side of the
frame using 2 bolts (3/8 x 1-1/4 inches), 2
washers and 2 locknuts (3/8 inch) (
).
Note:
One locknut is from loose parts and the
other is used from earlier removal.
g206982
Figure 5
1.
Locknut (3/8 inch), existing
5.
Hole, existing in frame
2.
Forward hole, left side
6.
Washer
3.
Front left caster (caster
fork and wheel not shown
for clarity)
7.
Bolt (3/8 x 1-1/4 inches)
4.
Locknut (3/8 inch), loose
parts
8.
Left mounting bracket
5.
On the right side of the machine, install the right
weight-mounting bracket as follows:
•
For machines without a foot assist lift pedal,
secure the bracket using 2 bolts (3/8 x 1-1/4
inches), 2 washers and 2 lock nuts (3/8 inch)
(
).
Note:
A locknut is from the loose parts and
the other is used from earlier removal.
g206981
Figure 6
1.
Front right caster (caster
fork and wheel not shown
for clarity)
5.
Bolt (3/8 x 1-1/4 inches)
2.
Forward hole, right side
6.
Washer
3.
Locknut (3/8 inch), existing
7.
Hole, existing in frame
4.
Right mounting bracket
8.
Locknut (3/8 inch), loose
parts
Note:
For machines with a foot assist lift
pedal, the washers are not used.
•
For machines with a foot assist lift pedal,
remove the forward fasteners in the foot
assist lift pedal bracket and secure the
bracket using 2 bolts and 2 lock nuts (
).
Note:
One locknut is from the loose parts
and the other is used from earlier removal.
g206980
Figure 7
6.
Install the weight bracket to the mounting
brackets by aligning the outboard holes in the
bracket with the mounting brackets installed
previously (
8
Summary of Contents for Quest 126-7510
Page 24: ......
