Exmark Quest 126-7510, Manual

Page: 11 / 24

g028305
Figure 13
1. Draw bar decal
5. Install the bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame.
Note:
Repeat this step for the right side of the
machine.
g028306
Figure 14
Left side shown
1. Pivot frame hole 4. Support rod
2. Washer 5. Keyed slot, existing
3. Hairpin cotter 6. Bent, flared end of rod
6. Insert the bent ends of the rods into the
attachment mount as shown in
Figure 14 and
secure the end of each rod with a washer and
hairpin cotter.
For 2011 through 2014 Models
Only
Note:
The stabilizer bracket is not used on 2011
through 2014 models.
Note:
For 2011 through 2014 models, the rear-engine
guard is optional for this bagger.
1. Install the pivot frame to the machine frame.
Secure the pivot frame to the machine frame
using two bolts (5/16 x 1 inch) and two locknuts
(5/16 inch).
1
2
3
4
5
g030496
g030496
Figure 15
1. Machine frame 4. Bolt (5/16 x 2-1/2 inch)
2. Locknut (5/16 inch) 5. Pivot frame
3. Hole 6. Rear-engine guard
(optional)
2. Secure the pivot frame to the bottom of the
machine frame using two self-tapping screws
(5/16 x 3/4 inch).
11