Installation Instructions
Important:
For Serial Numbers 313,000,000 and Higher,
multiple accessories added to a base unit can change the
stability of the machine. Read the unit operator’s manual
to determine if counterbalance weights are necessary for
the accessories installed on the unit.
1.
Make sure all moving parts have stopped, parking brake
is engaged, and the key has been removed.
2.
Raise the front of the machine and support with jack
stands.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
3.
Remove the blades; retain for removal of the finish cut
kit.
4.
If the mower has been used, scrape underside of
mower deck clean.
5.
Remove the hardware that plugs the exposed mounting
holes in the deck.
•
On 60 inch decks, remove the six 5/16-18 x 3/4
inch hex socket screws and flanged nyloc nuts
plugging the exposed mounting holes in the deck.
Retain for future use (see Figure 3).
Figure 3
1.
Remove and retain hardware
•
On 72 inch decks, remove the four 5/16-18 x 3/4
inch hex socket screws and flanged nyloc nuts
plugging the exposed mounting holes in the deck.
Also remove the inboard tire flap fastener on each
side. Retain for future use (Figure 4).
Figure 4
1.
Remove and retain hardware
Note:
Refer to Figure 1 for steps 6 through 12.
6.
Remove and retain the four 3/8-16 x 2 1/4 inch
carriage bolts and flanged nyloc nuts within the cutting
chamber that attach the side bumpers to the deck sides.
7.
Loosely install the outer forward baffles first (items 1
and 2). Re-use part of the hardware removed in step
6, along with one 3/8-16 x 7/8 inch carriage bolt and
flanged nyloc nut per baffle.
8.
Loosely install the center forward baffle (item 3) with
three 3/8-16 x 7/8 inch carriage bolts and nyloc nuts.
9.
Loosely install the outer rear baffles (items 4 and 5).
Re-use the remaining hardware removed in step 6,
along with one 3/8-16 x 7/8 inch carriage bolt and
flanged nyloc nut per baffle. Note that the front baffle
installs between the rear baffle tabs.
Note:
72 inch units will use one 5/16-18 x 1 inch
carriage bolt and nyloc nut in the rear of each outer
baffle.
10.
Loosely install the rear center baffle (item 6) using two
3/8-16 x 7/8 inch carriage bolts and flanged nyloc nuts.
This baffle installs between the front baffle flanges as
shown in Figure 5.
Figure 5
1.
3/8-16 x 7/8 inch carriage
bolt
3.
Front baffle flange
2.
Rear center baffle
4.
Flanged nyloc nut
4
Summary of Contents for 116-8547
Page 3: ...Figure 2 3 ...