EXIT Toys 8633960640, User Manual

Page: 59 / 98

12
MSP-30106-V02
Step 6 Fill the pool
WARNING: Do not leave pool unattended while filling with water.
WARNING: If more than 1~2
inches of water collects on any
one side before you
start filling in the center.The pool
is not level enough, and must be
corrected! You
shall pull out the drain plug,
release the water completely,
disassemble the pool
completely,locate the pool on
a plane surface, repeat set up
instructiion.
WARNING: DO NOT OVERFILL as this could cause the pool to collapse.In times of
heavy rainfall you may need to empty some of the water to ensure the level is
correct.
6.1. Make sure the drain fitting is plugged securely and the cap
is in place. Start filling the pool with water. After about 1-inch of
water is on the bottom, stop filling and smooth wrinkles out of the
bottom of the pool. Pull the outer wall out from the top edge, all
around the bottom of the pool, so that it fills evenly.
6.2. Continue filling the pool until water level .
6.0 Disassembly and storage
WARNING: Do not let your children stand at downfold and face the water outlet
during the drainage. The water current may sweep your children.
WARNING: Pool should be stored at places where it is cool and dry, with no sharp
object surrounded, or no heavy objects lying above, which may cause damage to the
pool.
Step 1. I f you have a filter pump,make sure that the electricty source to the filter
pump has been disconnected.
Step 2. Check to ensure that the out drain plug is firmly inserted on the inside of the
pool.
Step 3. Attach your garden hose to the drainage valve connector, and placing the
other end of the hose in an area where the water can drain safely,such as a storm
drain or street gutter.Remember that because water always finds its own level,the
end of the hose must be lower in elevation than the pool to ensure complete
drainage.
Step 4. If you have a filter pump, insert the stopper into the inlet and outlet fixtures,
on inside of pool, and then disconnect the filter pump hoses.
90 %