ORCA-50 UHF Demo Manual V1.0
16 Eximia Srl
–
www.eximia.it
- www.rfidstore.it
The output power range is 0dBm - 33dBm. The default value is 30dBm (1 W). After this value is set, it will
be automatically saved inside the machine, the machine is not lost after power failure
。
1.5.2Set the radio frequency spectrum specification
In different areas, there are different requirements for radio frequency spectrum.
There are two ways to set the reader's spectrum.
Method 1: Use the default frequency of the reader.
The default frequency of the reader can refer to the frequency parameter correspondence table in the
communication protocol.
The reader supports a frequency range of 865MHz - 868MHz, 902MHz - 928MHz.
Use the drop-down boxes and buttons shown below to set the desired operating frequency range
。
When setting the spectrum range, please note the following points
：
◆
The starting frequency and end frequency can not exceed the range of RF specifications.
