EXFO IQS-5320, User Manual, Page: 34 / 177

Setting Up Your Multi-Wavelength Meter
Multi-Wavelength Meter
25
Creating Channels and Channel Lists
For details on defining reference channel parameters, see
Defining New
Channels with Equal Spacing on page 26.
Center Expected wavelength of the channel peak. It must be given
in the unit in use (nm or THz).
The channel center may be located anywhere in the module
range.
Width The length of the interval centered on the expected
wavelength. It must be given in GHz.
Values from 5.0 to 2000.0 GHz are allowed.
If two or more measured channels correspond to one
defined channel, parentheses will be added to the ID of all
but the strongest peak on the
Results
tab.
Alarm Alarm is a tolerance interval within which the channel peak
must occur. It must be given in GHz.
If the channel peak is outside this interval, a beep will be
heard and an exclamation mark (!) may appear next to the
channel in the various application lists.
P Max P Max is the upper limit of the peak power. It must be given
in the unit being used (W or dBm).
If the channel peak power is greater than P Max, a beep will
be heard and an exclamation mark (!) may appear next to
the channel in the various application lists.
Values from –39.9 to +10.0 dBm are allowed. P Max must be
greater than P Min.
P Min P Min is the lower limit of the peak power. It must be given
in the unit being used (W or dBm).
If the channel peak power is less than P Min, a beep will be
heard and an exclamation mark (!) may appear next to the
channel in the various application lists.
Values from –40.00 to +9.99 dBm are allowed. P Min must
also be less than P Max.
Parameter Description
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com